Stability of Different Types of Power Factor Correction

Stability of Different Types of Power Factor Correction
Author: Reham Haroun Mohamed
Publisher: LAP Lambert Academic Publishing
Total Pages: 184
Release: 2012-05
Genre:
ISBN: 9783659115455

Single phase high power factor rectification is the most frequently accomplished using a boost converter. The input current shaping approach results in low line currents harmonic distortion and a power factor close to unity at the interface between the ac line and the rectifier. Various techniques are available for active current shaping, average current mode control, nonlinear control and one cycle control. Most of them are now supported by dedicated integrated circuits. Average-current-mode control is the regular control where the inductor current is forced to follow the input voltage. Recently nonlinear phenomena have been obvious in AC/DC converters which results in unstable regime such as period doubling and chaos. During these operating regimes, the input current distorts and therefore, breaks the operation of PFC converters. In this book, a study for stability for the three practical controls of boost PFC converter is introduced. Each technique has been tested to determine the practical limitation for stable regions. Design guidelines are made clear for stable operation in the examined control techniques. Experimental results confirm simulation with good matching.

Renewable Energy

Renewable Energy
Author: Thomas Hammons
Publisher: BoD – Books on Demand
Total Pages: 592
Release: 2009-12-01
Genre: Technology & Engineering
ISBN: 9537619524

Renewable Energy is energy generated from natural resources - such as sunlight, wind, rain, tides and geothermal heat - which are naturally replenished. In 2008, about 18% of global final energy consumption came from renewables, with 13% coming from traditional biomass, such as wood burning. Hydroelectricity was the next largest renewable source, providing 3% (15% of global electricity generation), followed by solar hot water/heating, which contributed with 1.3%. Modern technologies, such as geothermal energy, wind power, solar power, and ocean energy together provided some 0.8% of final energy consumption. The book provides a forum for dissemination and exchange of up - to - date scientific information on theoretical, generic and applied areas of knowledge. The topics deal with new devices and circuits for energy systems, photovoltaic and solar thermal, wind energy systems, tidal and wave energy, fuel cell systems, bio energy and geo-energy, sustainable energy resources and systems, energy storage systems, energy market management and economics, off-grid isolated energy systems, energy in transportation systems, energy resources for portable electronics, intelligent energy power transmission, distribution and inter - connectors, energy efficient utilization, environmental issues, energy harvesting, nanotechnology in energy, policy issues on renewable energy, building design, power electronics in energy conversion, new materials for energy resources, and RF and magnetic field energy devices.

Transfer Functions of Switching Converters

Transfer Functions of Switching Converters
Author: Christophe P Basso
Publisher: Faraday Press
Total Pages: 704
Release: 2021-06-22
Genre:
ISBN: 9781949267518

Transfer Functions of Switching Converters teaches readers how to determine transfer functions of switching power supplies commonly encountered in consumer and industrial markets. The book starts with a smooth introduction to switching cells, going into the details of the first steps of linearization and small-signal modulation. You will then learn how the PWM switch model was derived and how to apply it to the basic structures operated in fixed switching frequency and various operating conditions like continuous and discontinuous modes in voltage- or current-mode control. The model is extended to other control schemes like quasi-resonance, constant on- and off-time converters, all with an associated small-signal version. The following chapters explore the founding structures like the buck, the boost and buck-boost cells, later covering their isolated versions like forward or flyback converters. The last chapter deals with more complicated structures like Ćuk, Zeta, SEPIC and LLC.

Nonlinear Phenomena in Power Electronics

Nonlinear Phenomena in Power Electronics
Author: Soumitro Banerjee
Publisher: Wiley-IEEE Press
Total Pages: 480
Release: 2001-07-16
Genre: Mathematics
ISBN:

Brings the knowledge of 24 experts in this maturing field out from the narrow confines of academic circles, and makes it accessible to graduate students and power electronics professionals alike. * Provides practicing engineers with the knowledge to predict power requirement behavior. * The insights gained from this all-inclusive compilation will ultimately lead to better design methodologies.