The Metallurgy of Lead

The Metallurgy of Lead
Author: John Percy
Publisher: Forgotten Books
Total Pages: 700
Release: 2017-09-17
Genre: Science
ISBN: 9781527776401

Excerpt from The Metallurgy of Lead: Including Desilverization and Cupellation IT was intended that this volume should contain the Metallurgy Of Lead, Silver, and Gold; but it has been found impossible to treat those important subjects in a sufficiently detailed and com prehensive manner in a single volume without making it so thick and heavy as to be inconvenient. It has, therefore, been decided to restrict this volume to the Metallurgy Of Lead, including the processes of Desilverization and Cupellation. The Author does not regret the change in the plan of publication, because the delay in publishing the Metallurgy of Silver and Gold will, there is reason to hope, enable him to procure valuable and additional information from California and elsewhere on those subjects for the next volume, of which a considerable portion is already in print. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

The Metallurgy of Lead Silver, Vol. 1 of 2 (Classic Reprint)

The Metallurgy of Lead Silver, Vol. 1 of 2 (Classic Reprint)
Author: Henry F. Collins
Publisher: Forgotten Books
Total Pages: 438
Release: 2017-09-17
Genre: Technology & Engineering
ISBN: 9781528471206

Excerpt from The Metallurgy of Lead Silver, Vol. 1 of 2 When silver is melted and cooled slowly, octahedral crystals can be obtained. When melted in the air it absorbs twenty-two times its volume of oxygen, which is, however, given off on solidification. This phenomenon called sprouting is peculiar to silver which is nearly pure, comparatively small quantities of copper or of lead destroying its property of sprouting. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

The Metallurgy of Lead Silver, Vol. 1

The Metallurgy of Lead Silver, Vol. 1
Author: Henry F. Collins
Publisher: Forgotten Books
Total Pages: 454
Release: 2019-01-31
Genre: Technology & Engineering
ISBN: 9780365351078

Excerpt from The Metallurgy of Lead Silver, Vol. 1: Lead; Being One of a Series of Treatise on Metallurgy Written by Associates of the Royal School of Mines Being one of a Series of Treatises on Metallurgy written by Associates of the Royal School of Mines. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

The Metallurgy of Lead and the Desilverization of Base Bullion (Classic Reprint)

The Metallurgy of Lead and the Desilverization of Base Bullion (Classic Reprint)
Author: Henrich Oscar Hofman
Publisher: Forgotten Books
Total Pages: 480
Release: 2017-11-05
Genre: Technology & Engineering
ISBN: 9780260360854

Excerpt from The Metallurgy of Lead and the Desilverization of Base Bullion In.ib7o Dr. Percy published his great work, The Metallurgy of Lead, Including Desilverization and Cupellation, which has become the standard book for England and America, and is also highly esteemed by the Germans and the French, into whose lan guages it has been translated. It contains an exhaustive discus sion of smelting and desilverizing as carried on in the principal European works. During the past twenty years, however, so much that is new has been introduced in American practice that a book embodying the latest improvements seems almost a neces sity for the student. It is the aim of the present work to supply this need. Thus, while European practice is not at all excluded from the book, the main Object has been to make it a guide for Americans, and European methods have been discussed more in connection with their applicability in this country than from any other point of view. In the subject of the blast-furnace, for in stance, only such features have been brought out as seemed useful for America. Reverberatory-furnace practice, on the other hand, which has not made much progress as yet in this country, is given more in the European way, while the ore-hearth treatment follows both English and American methods, which supplement one an other. Three classes of readers have been kept in mind - the stu dent, for whose use the ground principles and many definitions are given a prominent place; the metallurgist, who needs minute de tail for his practical operations; and the investigator, who will find in the foot-notes the principal references for the subject in. Its. Various branches. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

Metallurgy of Lead (Classic Reprint)

Metallurgy of Lead (Classic Reprint)
Author: H. O. Hofman
Publisher: Forgotten Books
Total Pages: 684
Release: 2018-02-07
Genre: Technology & Engineering
ISBN: 9780656043231

Excerpt from Metallurgy of Lead The first discovery of argentiferous lead ore was made in 1863 in Little Cottonwood Canyon, Utah; the first smelting of such ores was carried on in 1865 at Argenta, Mont; in 1867 similar ores were found at White Pine, Nev., and smelting was begun at Oreana, Nev. In 1869 the mines of Eureka, Nev discovered in 1864, were opened up, and the treatment of ores was begun in the following year. Next came Utah, where smelteries were erected in 1870, followed by Colorado, which came into prominence in 1878. Later Idaho, New Mexico, and Arizona were added to the list. Colorado for many years was the largest producer of lead ores, but it has been outranked by Idaho and Utah since the exhaustion of the wonderful mines of Leadville after 1890; it furnishes at present only 6 - 7 per cent. Of the country's product, and this high figure is largely due to the central smelting works of Denver and Pueblo which treat more lead ore mined outside of the state than produced in it. The manner in which prehistoric people extracted lead from ore is unknown. If we recall that oxide and sulphide ores readily give up lead when heated with charcoal, we can imagine that the accidental discovery of this fact may have led to the most primitive furnace, a small pit dug into the ground and enclosed by stones to form a small shaft. If at first such furnaces were worked by natural draft, blast (reeds, bellows) must have been applied to produce the temperature required to form slag. The furnaces (cavity 30 in. Deep, side-walls 26 in. High, 2 tuyere-openings) found in Sinai in which copper ores were smelted about 4000 b.c.1 had this form; the furnaces of Laurium were similar. In early times low shaft furnaces with natural or forced draft formed the ap paratus, and charcoal the fuel. Agricola2 states that in 1556 the inhabitants of the present Austrian province of Carinthia used what may be called a closed stall with inclined bottom for treating galena; they kindled a wood fire and charged the ore upon it, whereupon lead was liberated and, trickling down the hearth, was collected in a basin. Similar contrivances, the Log-furnace and Ash-furnace, were used in smelting ores in the Mississippi valley about 1720. These were in operation until 1836, when the first Scotch ere-hearth was erected. Percy' states that in 1730 the ore-hearth was in operation in Derbyshire, England. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

Innovations in the Metallurgy of Lead (Classic Reprint)

Innovations in the Metallurgy of Lead (Classic Reprint)
Author: Dorsey A. Lyon
Publisher: Forgotten Books
Total Pages: 178
Release: 2018-03-04
Genre: Science
ISBN: 9780666867438

Excerpt from Innovations in the Metallurgy of Lead The staff at present assigned by the Bureau of Mines to the department consists oiz The metallurgist in Charge, a metallurgist, an assistant metallurgical engineer, a metallurgical assistant, 5. Geologist and microscopist, a junior chemist, a chief clerk, a junior clerk, and a stenographer. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

Handbook of Metallurgy, Vol. 1

Handbook of Metallurgy, Vol. 1
Author: Carl Schnabel
Publisher: Forgotten Books
Total Pages: 920
Release: 2017-10-26
Genre: Science
ISBN: 9780266765820

Excerpt from Handbook of Metallurgy, Vol. 1: Copper, Lead, Silver, Gold IT is a curious fact that there does not exist in the English language a single complete treatise on Metallurgy. There are a number of smaller text-books, mainly adapted to the use of students, which cover the entire field, but make no pretence of describing it with any thoroughness of detail; and there are a number of very admirable works dedicated to the metallurgy of individual metals. Had my respected teacher, the late Dr. John Percy, ever carried out his magnificent idea of a comprehensive series of volumes on this subject, the ideal of. An exhaustive work on Metallurgy would have been produced, although its bulk would have attained the formidable dimensions of a small library in itself - an advantage perhaps to the specialist, but a less commendable feature for those who have to deal with general Metallurgy. Such being the position of our literature of this subject, I venture to think that I am rendering the English metallurgist a distinct service in submitting to him a translation of the most recent and most exhaustive work on the subject in any language, from the pen of that eminent metallurgical authority, Dr. C. Schnabel, of Clausthal. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

Lead and Its Compounds (Classic Reprint)

Lead and Its Compounds (Classic Reprint)
Author: Thomas Lambert
Publisher: Forgotten Books
Total Pages: 282
Release: 2017-10-23
Genre: Science
ISBN: 9780265657737

Excerpt from Lead and Its Compounds IN the present volume the author has endeavoured to.show the great strides made in the metallurgy of lead and zinc, and to incorporate in it the latest applications of electrical science, not only in cleansing the ores, but also in their after treatment. The work also contains a description of the pigments of both metals, their manufacture and properties; and to make this portion as comprehensive as possible, the drying oils and siccatives, and their relation to pigments, are dealt with. In addition to other information of importance to the colourist, the value of the work is enhanced by a chapter devoted to the assaying and analysis of lead and zinc ores, and the quantitative testing of paints and oils. The book is divided into seventeen chapters, and is illustrated with forty drawings, specially made by Mr. Levi Lambert, to whom great credit is due. In conclusion, the author hopes the work will be studied with advantage by those engaged in the above branches of industry. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.

A Textbook on Metallurgy of Gold, Silver, Copper, Lead, and Zinc (Classic Reprint)

A Textbook on Metallurgy of Gold, Silver, Copper, Lead, and Zinc (Classic Reprint)
Author: International Correspondence Schools
Publisher: Forgotten Books
Total Pages: 648
Release: 2018-07-29
Genre:
ISBN: 9781390308860

Excerpt from A Textbook on Metallurgy of Gold, Silver, Copper, Lead, and Zinc Ordinarily, the greater part of the heat given to a body is spent in raising its temperature, and but little is used in expanding the body. That is, the quantity 5 is nearly equal to the quantity Q, while the quantities I and IV are nearly nothing. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.