Experimental Investigation of a Thrust Augmenting Ejector

Experimental Investigation of a Thrust Augmenting Ejector
Author: Hidayat Wiradimadja
Publisher:
Total Pages: 0
Release: 1985
Genre:
ISBN:

An ejector is basically a jet pump in which the kinetic energy of the jet is made to impart motion to the fluid surrounding it. During this process, in a well design system, the ejector as a whole experiences a thrust much higher than that of the jet alone. In principle, an ejector is nothing but a jet surrounded by a shroud. This investigation concerns the performance of a two- dimensional ejector with its primary jet excited by a novel method. A constant area duct was used in this experiment. The velocity of the jet at the exit was subsonic. Maximum thrust was obtained when the ejector to jet exit area ratio was about 35. Under this condition a thrust augmentation ratio of 1.65 was achieved, with the jet excited at 20 Hz, whereas without excitation it was only 1.40. The mixing characteristics of the jet under excitation was examined using flow visualization techniques. Smoke filaments illuminated by a sheet of powerful light and schlieren optics with the jet heated were used. Excitation of the jet was found to generate large vortex-like flow structures which might be responsible for enhanced mixing. These vortices extended to considerable distances on both sides of the jet.

Experimental Investigation of Thrust Augmenting Ejectors Using Vane Excited Primary Jets

Experimental Investigation of Thrust Augmenting Ejectors Using Vane Excited Primary Jets
Author:
Publisher:
Total Pages: 0
Release: 1982
Genre:
ISBN:

An experimental investigation has been conducted to evaluate the entrainment characteristics of a thrust augmenting ejector, with a small, oscillating airfoil inserted in the potential core of the primary jet. Velocity distributions were measured across the width of the jet, at downstream distances of 20 and 40 nozzle widths, with the jet exhausting into still air and with the jet exhausting into an instrumented ejector shroud for the following range of parameters: Pressure ratio 1.137 and 1.268, amplitude of oscillation 2.6 deg and 6.9 deg zero-to-peak frequency of oscillation 0, 20, 40 and 60 Hz. Static pressure distributions were measured within the shroud when the jector was installed. The results amplify previously conducted studies. Jet spreading and entrainment appear to increase with increasing amplitude and frequency of oscillation and to decrease with increasing nozzle pressure ratio. (Author).

Experimental Investigation of Thrust Augmenting Ejectors Using Vane Excited Primary Jets

Experimental Investigation of Thrust Augmenting Ejectors Using Vane Excited Primary Jets
Author: Thomas Robert McClellan
Publisher:
Total Pages: 143
Release: 1982
Genre: Aeronautics
ISBN:

An experimental investigation has been conducted to evaluate the entrainment characteristics of a thrust augmenting ejector, with a small, oscillating airfoil inserted in the potential core of the primary jet. Velocity distributions were measured across the width of the jet, at downstream distances of 20 and 40 nozzle widths, with the jet exhausting into still air and with the jet exhausting into an instrumented ejector shroud for the following range of parameters: Pressure ratio 1.137 and 1.268, amplitude of oscillation 2.6 deg and 6.9 deg zero-to-peak frequency of oscillation 0, 20, 40 and 60 Hz. Static pressure distributions were measured within the shroud when the jector was installed. The results amplify previously conducted studies. Jet spreading and entrainment appear to increase with increasing amplitude and frequency of oscillation and to decrease with increasing nozzle pressure ratio. (Author).

Experimental Investigation of Thrust Augmenting Ejector Flows

Experimental Investigation of Thrust Augmenting Ejector Flows
Author: L. Bernal
Publisher:
Total Pages: 19
Release: 1982
Genre:
ISBN:

The results of two investigations, one recently completed on pulsatile ejector flows and the second currently in progress on a two-dimensional ejector configuration are presented. The objective of these investigations is to determine the role of entrained fluid and its mixing with the primary jet on ejector performance. Results will also be presented on the effects of entrance geometry on ejector entrainment and thrust augmentation.

Experimental Investigation of High Performance, Short, Thrust Augmenting Ejectors

Experimental Investigation of High Performance, Short, Thrust Augmenting Ejectors
Author:
Publisher:
Total Pages: 69
Release: 1983
Genre:
ISBN:

Results of an experimental investigation concerning the design and testing of air-to-air thrust augmenting ejectors utilizing short curved-wall diffusers are presented. These ejectors were designed primarily according to the procedure established in an analytical research effort sponsored by DTNSRDC from 1980-1981. Two of the three ejectors tested have identical mixing chambers. The mixing chamber inlet area to the primary nozzle area ratio lambda was 40. The overall ejector length-to-mixing chamber diameter ratios L/D(overall) were 6.09 and 6.16; diffuser area ratios AR(diff) were 1.33 and 1.46, respectively. The third ejector had an L/D(overall) of 6.02, a lambda of 20 and an AR(diff) of 1. 26. The best observed thrust augmentation ratio phi and the modified thrust augmentation ratio phi sub 2 were 2.11 and 1.91 respectively for a sonic primary jet. The modified thrust augmentation ratio phi sub 2 accounts for the penalty of suction in preventing flow separation in the diffuser. These levels of thrust ratio were derived from velocity measurements at the ejector exit. Independent thrust measurements obtained with strain gages on the mixing chamber agree with the force calculated from the momentum data. The experimentally observed ejector performance data correlated well with the predicted values. (Author).

An Experimental Investigation of Two-Dimensional Thrust Augmenting Ejectors

An Experimental Investigation of Two-Dimensional Thrust Augmenting Ejectors
Author: L. Bernal
Publisher:
Total Pages: 104
Release: 1984
Genre:
ISBN:

Experiments were performed with subsonic and underexpanded choked two-dimensional primary nozzle ejector flow systems without diffusion to evaluate the role of entrainment and mixing in thrust augmentation. Two-component Laser Doppler velocity measurements (mean and fluctuating values), thrust measurements, ejector shroud surface pressure measurements and flow visualization were used to determine the evolution of the velocity profiles and their relationship to the ejector performance. Key findings include: (1) Primary jet growth is significantly altered by the ejector shroud. (2) Primary jet turbulent characteristics when normalized with the local mean centerline velocity are in agreement with those for the free-jet. (3) In the neighborhood of the ejector shroud the flow field can be classified into two regions--the potential flow region and the region close to the ejector exit which is dominated by the turbulent transport. (4) Pressure recovery is very sharp in the first region and is more gradual in the region close to the ejector exit. The investigation is continuing toward the near-term objectives of obtaining measurements within diffused flow and with heated primary air. This volume emphasizes the laser doppler velocimetry developed especially for this program. Part II (AD-A154 083) presents detailed cold flow measurements along with preliminary primary hot flow data.

An Experimental Investigation of a Circular Thrust Augmenting Ejector

An Experimental Investigation of a Circular Thrust Augmenting Ejector
Author: Generoso C. Uhuad
Publisher:
Total Pages: 115
Release: 1985
Genre:
ISBN:

A 4.4 in diameter circular ejector was tested to determine the effect on thrust augmentation ratio of the primary nozzle height and injection angle. Also tested were the effects of alternating primary nozzle injection angles, diffuser blowing and suction, inlet cross flow and low primary nozzle exit velocities on thrust augmentation. The results showed that both the primary nozzle injection angle and height affect the maximum thrust augmentation ratio attainable. A small amount of cross flow at the inlet increased the maximum thrust augmentation. The alternating primary nozzle injection angle arrangement did not increase the maximum thrust augmentation above that which was obtained using uniform primary nozzle injection angles. Diffuser blowing or suction did not provide an improvement in the maximum thrust augmentation above that which was obtained without diffuser boundary layer control. Finally, at low primary nozzle exit velocities, thrust augmentation increase as the nozzles were moved out along the inlet surface. The increase in thrust augmentation is attributed to the ability of the flow to remain attached to the inlet surface at low primary nozzle exit velocities thereby increasing the ejector effective mixing chamber length. (Author).

An Experimental Investigation of Unsteady Thrust Augmentation Using a Speaker-Driven Jet

An Experimental Investigation of Unsteady Thrust Augmentation Using a Speaker-Driven Jet
Author: National Aeronautics and Space Administration (NASA)
Publisher: Createspace Independent Publishing Platform
Total Pages: 32
Release: 2018-06-21
Genre:
ISBN: 9781721635603

An experimental investigation is described in which a simple speaker-driven jet was used as a pulsed thrust source (driver) for an ejector configuration. The objectives of the investigation were twofold: first, to add to the experimental body of evidence showing that an unsteady thrust source, combined with a properly sized ejector generally yields higher thrust augmentation values than a similarly sized, steady driver of equivalent thrust. Second, to identify characteristics of the unsteady driver that may be useful for sizing ejectors, and predicting what thrust augmentation values may be achieved. The speaker-driven jet provided a convenient source for the investigation because it is entirely unsteady (having no mean component) and because relevant parameters such as frequency, time-averaged thrust, and diameter are easily variable. The experimental setup will be described, as will the various measurements made. These include both thrust and Digital Particle Imaging Velocimetry of the driver. It will be shown that thrust augmentation values as high as 1.8 were obtained, that the diameter of the best ejector scaled with the dimensions of the emitted vortex, and that the so-called Formation Number serves as a useful dimensionless number by which to characterize the jet and predict performance. Paxson, Daniel E. and Wernet, Mark P. and John, Wentworth T. Glenn Research Center NASA/TM-2004-212909, AIAA Paper 2004-0092, E-14332