Aerodynamic Effect Of Strakes On Two Dimensional Tail Boom Models Of The Oh 58a And The Oh 58d Helicopters
Download Aerodynamic Effect Of Strakes On Two Dimensional Tail Boom Models Of The Oh 58a And The Oh 58d Helicopters full books in PDF, epub, and Kindle. Read online free Aerodynamic Effect Of Strakes On Two Dimensional Tail Boom Models Of The Oh 58a And The Oh 58d Helicopters ebook anywhere anytime directly on your device. Fast Download speed and no annoying ads. We cannot guarantee that every ebooks is available!
Author | : National Aeronautics and Space Adm Nasa |
Publisher | : |
Total Pages | : 36 |
Release | : 2018-10-22 |
Genre | : |
ISBN | : 9781729082461 |
During hover and low speed flight, helicopters experience significant aerodynamic forces on the tail boom caused by the wake from the main and tail rotors and by crosswinds. These effects were simulated during a study conducted in the Langley 14 by 22 Foot Subsonic Tunnel on a 136 percent scaled 2-D tail boom model with cross sections representative of those on the U.S. Army OH-58A and the OH-58D helicopters. The effects of longitudinal strakes attached to the cross sections were studied. To obtain the aerodynamic forces acting on the cross sections, the flow incidence range on the scaled models was varied from -45 to 90 degrees and the models were tested through a dynamic pressure range of 5 to 15 psf. The results of the OH-58A and the OH-58D configurations show a significant improvement at conditions which represent right sideward flight by reducing the adverse aerodynamic side force when the strakes are installed. These data were used to calculate a change in tail rotor power for the full scale flight vehicle and indicated approx. a 5 to 6 percent average savings in right sideward flight for the critical velocity range of 0 to 30 knots. Increases in the tail boom normal force were noted due to the strakes. The results indicate a potential for reducing the directional control and tail rotor thrust required in the critical hover and right sideward flight speed range with a calculated minimum increase to main rotor power required and an overall net improvement in power of 0.5 percent for both the OH-58A and OH-58D. Crowell, Cynthia A. and Kelley, Henry L. Langley Research Center DA PROJ. 1L1-62211-A-47-A; RTOP 505-61-51-10...
Author | : Cynthia A. Crowell |
Publisher | : |
Total Pages | : 40 |
Release | : 1990 |
Genre | : Helicopters |
ISBN | : |
Author | : Cynthia A. Crowell |
Publisher | : |
Total Pages | : 40 |
Release | : 1990 |
Genre | : |
ISBN | : |
Author | : Henry L. Kelley |
Publisher | : |
Total Pages | : 36 |
Release | : 1992 |
Genre | : Helicopters |
ISBN | : |
Author | : |
Publisher | : |
Total Pages | : 272 |
Release | : 1991 |
Genre | : Aeronautics |
ISBN | : |
Author | : |
Publisher | : |
Total Pages | : 280 |
Release | : 1990 |
Genre | : Aeronautics |
ISBN | : |
Author | : |
Publisher | : |
Total Pages | : 1638 |
Release | : 1995 |
Genre | : Government publications |
ISBN | : |
Author | : |
Publisher | : |
Total Pages | : 898 |
Release | : 1995 |
Genre | : Government publications |
ISBN | : |
Author | : |
Publisher | : |
Total Pages | : 1566 |
Release | : 1991 |
Genre | : Science |
ISBN | : |
Author | : Daniel W. Banks |
Publisher | : |
Total Pages | : 56 |
Release | : 2000 |
Genre | : Helicopters |
ISBN | : |
Two large-scale, two-dimensional helicopter tail boom models were used to determine the effects of passive venting on boom down loads and side forces in hovering crosswind conditions. The models were oval shaped and trapeziodal shaped. Completely porous and solid configurations, partial venting in various symmetric and asymmetric configurations, and strakes were tested. Calculations were made to evaluate the trends of venting and strakes on power required when applied to a UH-60 class helicopter. Compared with the UH-60 baseline, passive venting reduced side force but increased down load at flow conditions representing right sideward flight. Selective asymmetric venting resulted in side force benefits close to the fully porous case. Calculated trends on the effects of venting on power required indicated that the high asymmetric oval configuration was the most effective venting configuration for side force retention, and the high asymmetric with a single strake was the most effective for overall power reduction. Also, curves of side force versus flow angle were noticeably smoother for the vented configurations compared with the solid baseline configuration; this indicated a potential for smoother flight in low-speed crosswind conditions.